Edge-Core EWS4502 Guía de instalación descargar pdf (Pagina 34)

Chapter 6

| Wireless Controller Management

How to Connect to the Console Port

– 36 –

How to Connect to the Console Port

The RJ-45 Console port on the wireless controller’s front panel is used to connect to

the unit for out-of-band console configuration. The console device can be a PC or

workstation running a VT-100 terminal emulator, or a VT-100 terminal. An RJ-45-to-

DB-9 cable is supplied with the wireless controller for connecting to a PC’s RS-232

serial DB-9 DTE (COM) port.

Note:

To connect to notebooks or other PCs that do not have a DB-9 COM port, use

a USB to male DB-9 adapter cable (not included with the wireless controller).

Figure 16: Console Port

The following table describes the pin assignments used in the RJ-45-to-DB-9

console cable.

Table 7: System Status LEDs

LED Condition Status

Pwr/Sys On Green System is receiving power and running normally.

On Yellow System self-diagnostic test has detected a fault.

Off The system is not receiving power.

Console Port

Table 8: Console Cable Wiring

Switch’s 8-Pin

Console Port

Null Modem PC’s 9-Pin

DTE Port

6 RXD (receive data) <--------------------- 3 TXD (transmit data)

3 TXD (transmit data) ---------------------> 2 RXD (receive data)

5 SGND (signal ground) ----------------------- 5 SGND (signal ground)

No other pins are used.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39

Sin comentarios

Edge-Core EWS4502 Guía de instalación Pagina 34