Edge-Core EWS4502 Guía de instalación Pagina 30

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 51
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 29
Chapter 4
| Power and Grounding
How to Install the Power Injector
– 30 –
Note
:
Use cable strips to secure all cables to the pole.
How to Install the Power Injector
The power injector can be installed indoors on any horizontal surface, such as a
desktop or shelf, or on a wall.
Caution
:
Do not install the power injector outdoors. The unit is for indoor
installation only.
Caution
:
Install lightning protection at the power injector end of the Ethernet
cable, use a lightning arrestor immediately before the cable enters the building.
Figure 18: Connecting the Power Injector
1. Connect outdoor-rated Ethernet cable from the AP to the RJ-45 port labeled
“DATA & POWER OUT” on the power injector.
2. Connect a straight-through unshielded twisted-pair (UTP) cable from a local
LAN switch to the RJ-45 port labeled “DATA IN” on the power injector. Use
Category 5e or better UTP cable for 10/100/1000BASE-T connections.
AC Power Cord DATA & POWER OUT Port
DATA IN Port
1
2
3
1
3
2
Vista de pagina 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 50 51

Comentarios a estos manuales

Sin comentarios