Edge-Core ES3528M V1 Guía de instalación descargar pdf (Pagina 34)

3-6

Installing the Switch

Connecting to a Power Source

To connect a device to a power source:

1. Insert the power cable plug directly into the socket located at the back of the

device.

Figure 3-6. Power Sockets

2. Plug the other end of the cable into a grounded, 3-pin socket.

Note: For International use, you may need to change the AC line cord. You must

use a line cord set that has been approved for the socket type in your

country.

3. Check the front-panel LEDs as the device is powered on to be sure the Power

LED is lit. If not, check that the power cable is correctly plugged in.

4. If you have purchased a Redundant Power Unit, connect it to the switch and to

an AC power source now, following the instructions included with the package.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 59 60

Sin comentarios

Edge-Core ES3528M V1 Guía de instalación Pagina 34