Edge-Core ECS4610-26T Guía de instalación Pagina 74
- Pagina / 142
- Tabla de contenidos
- SOLUCIÓN DE PROBLEMAS
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
C
HAPTER
10
| Spanning Tree
Configuring STP Global Settings
– 74 –
network. (References to “ports” in this section means “interfaces,”
which includes both ports and trunks.)
◆ Root Hello Time — The interval (in seconds) at which this device
transmits a configuration message.
◆ Root Forward Delay — The maximum time (in seconds) this device
will wait before changing states (i.e., discarding to learning to
forwarding). This delay is required because every device must receive
information about topology changes before it starts to forward frames.
In addition, each port needs time to listen for conflicting information
that would make it return to a discarding state; otherwise, temporary
data loops might result.
◆ Topology Changes — The number of times the Spanning Tree has
been reconfigured.
◆ Last Topology Change Time — The time since the Spanning Tree was
last reconfigured.
WEB INTERFACE
To configure global settings for Spanning Tree:
1. Click Configuration, Spanning Tree, STP Global Setting.
2. Set the Spanning Tree Status to enabled.
3. Modify other required parameters.
4. Click Apply.
Figure 22: STP Global Setting
- Management Guide 1
- ECS4310-26T 1
- Gigabit Smart Switch 1
- ANAGEMENT 3
- ABOUT THIS GUIDE 5
- CONTENTS 7
- SECTION III APPENDICES 125 10
- – 11 – 11
- – 12 – 12
- – 13 – 13
- – 14 – 14
- GETTING STARTED 15
- 16
- 1 INTRODUCTION 17
- 18
- System Defaults 21
- Table 2: System Defaults 21
- INITIAL SWITCH CONFIGURATION 23
- Connecting to the Switch 24
- Figure 1: Login Page 24
- Figure 3: IP Settings Page 25
- Figure 4: User Accounts Page 26
- Changing a PC’s IP Address 27
- WEB CONFIGURATION 29
- 30
- 3 USING THE WEB INTERFACE 31
- 32
- Figure 5: Home Page 32
- Table 4: Main Menu 33
- 4 SYSTEM SETTINGS 37
- 38
- Displaying System Information 38
- Figure 7: System Information 38
- Setting a User Account 39
- Figure 8: System Password 39
- Setting an IP Address 40
- 5 PORT SETTINGS 45
- 46
- 6 LINK AGGREGATION 49
- 50
- Creating Trunk Groups 50
- CONFIGURING TRUNK SETTINGS 52
- Configuring Trunk Settings 53
- Configuring LACP 54
- 7 CREATING VLANS 57
- 58
- Assigning Ports to VLANs 58
- 8 VLAN STACKING 61
- 62
- VLAN Stacking Table 62
- VLAN Stacking Settings 63
- 9 IGMP SNOOPING 65
- 66
- Multicast Entry Table 66
- IGMP Snooping Setting 67
- 10 SPANNING TREE 71
- 72
- CONFIGURING STP PORT SETTINGS 75
- Configuring STP Port Settings 76
- Figure 23: STP Port Setting 78
- 11 QUALITY OF SERVICE 79
- 80
- Port-Based Priority 80
- DSCP-Based Priority 81
- Priority-to-Queue Mapping 82
- Table 9: CoS Priority Levels 83
- Packet Scheduling 84
- Figure 27: Packet Scheduling 85
- LINK LAYER DISCOVERY PROTOCOL 87
- Configuring LLDP 88
- Figure 28: LLDP Settings 88
- LLDP Neighbors 89
- Figure 29: LLDP Neighbors 90
- 13 SNMP SETTINGS 91
- 92
- Figure 30: SNMP Settings 93
- 14 PORT MIRRORING 95
- 96
- Figure 32: Port Mirroring 96
- 15 PORT SECURITY 97
- 98
- Figure 33: Port Security 98
- 16 BANDWIDTH CONTROL 99
- 100
- Figure 34: Bandwidth Control 100
- 17 JUMBO FRAME 101
- 102
- 18 MANAGEMENT ACCESS FILTER 103
- 104
- 19 MAC ADDRESS SECURITY 105
- 106
- Static MAC Addresses 106
- MAC ADDRESS FILTERING 107
- MAC Address Filtering 108
- 20 802.1X SECURITY 109
- 110
- 802.1X Global Settings 110
- 802.1X Port Settings 111
- Figure 40: 802.1X Setting 111
- WEB INTERFACE 112
- 21 GENERAL SECURITY SETTINGS 113
- Storm Control Setting 114
- Figure 42: IP Filter Setting 114
- Port Isolation 116
- Defence Engine 117
- 22 PORT STATISTICS 119
- 120
- Figure 46: Port Statistics 120
- 23 MANAGEMENT TOOLS 121
- 122
- Restoring Factory Defaults 122
- Figure 47: Software Upgrade 122
- Resetting the Switch 123
- Figure 49: Reboot Switch 123
- APPENDICES 125
- 126
- A SOFTWARE SPECIFICATIONS 127
- 128
- Management Features 128
- Management Information Bases 129
- B TROUBLESHOOTING 131
- 132
- GLOSSARY 133
- – 134 – 134
- – 135 – 135
- – 136 – 136
- DIUS is a logon 137
- – 138 – 138
- – 139 – 139
- – 140 – 140
- E072010-CS-R01 142
- 149100000083A 142
Relacionado con productos y manuales para Los conmutadores de red Edge-Core ECS4610-26T
(74 paginas)© 2020, manymanuals.es. Todos los derechos reservados | 0.026 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentarios a estos manuales