Edge-Core EC View Pro NMS 3000 Manual de usuario descargar pdf (Pagina 81)

HAPTER

| Asset Manager

WMI Device Scanning

– 83 –

Specifications in preliminary manuals

are subject to change without notice.

PRELIMINARY

■

Groups — Lists devices according to the rules customized by the

user.

◆ Reports — Under the Reports category, there are three NMS Reports:

■

Device List by vendor

■

Devices in Subnet

■

Devices Unreachable

To launc h a repo r t :

1. Go to Outline panel > Reports.

2. Select and double-click on a Report and it will open a separate tab on

the Asset Manager panel.

3. Select or input the required parameters on each report and select OK.

WMI DEVICE SCANNING

From the Asset Manager panel you can perform WMI device scanning of

WMI-enabled PCs in the network. WMI scanning provides system

information from PCs running a Windows operating system.

OTE

Before starting WMI scanning, you first must set up WMI Credential

profiles and enable WMI on network PCs. See “Access Profiles - WMI

Credential” on page 139.

To start WMI scanning, perform the following steps:

1. At the bottom of the Asset Manager panel, right-click on “Device

scanning (WMI).” You will see the WMI Scanner dialog box.

2. In the IP Address section, specify a single IP address or IP address

range to scan.

3. In the Windows Profile section, select the WMI profile to use for the

scan.

4. Click OK to start scanning. The status of scanning is displayed at the

bottom of the Asset Manager panel.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 160 161

Sin comentarios

Edge-Core EC View Pro NMS 3000 Manual de usuario Pagina 81